This unique foam can be laminated with Nitto’s advanced adhesive technology to seal (complex) gaps against water, wind, dust, noise and heat.
- Soft -closed cell foam
- Acrylic-based adhesive
- Non-woven carrier
- Acrylic-based adhesive
- Release liner
High-end tape for LSE (low surface energy)
| Foam thickness | 3 - 25 mm |
| Tensile strength | 125 kPa |
| Elongation | 450% |
| Density | 130 kg/m³ |
| Compression load | (33%) 21 kPa |
| Waterabsorption (50%) | 2.5% |
| Watertightness (30%) | No leakage |
- The performance of Nitto EPT-Sealer on specific substrate must be assured by the user before implementation.
- During storage and transport, do not over stack the product, as this may cause deformation.
-EPT-Sealer should be applied to clean and dry surface. Remove excess oil, moisture and dirt from the substrate surface to which the sheet is applied.
- In order to avoid entrapped air-bubbles, tension and shear, the customer should determine appropriate application conditions.
- The best application conditions are obtained at a temperature between 15 °C and 40 °C.
- Appropriate compression is needed to have sealing performance.
- In case of use of primer, check beforehand the impact of the primer to the performance of the EPTSealer. Wrong use of primer can lead to loss of adhesion.
- Please consult Nitto Europe for any robotic application regarding more specific precautions.- Thickness as referred in orders, article description and on the packaging is related to the foam and is excluding tape and release liner thickness.
TEL +32-89-360111
Business Hours (WET) 8:00h-17:00h
Except for Sat, Sun, and Holidays
Nitto is present in 14 countries in the EMEA region. Find your local contact details here.
